-10-
Monitor
1. Press and hold the button more than 2 seconds to activate the Monitor
Function, you will hear background noise and possible weak signal from
the unit, when you released less than 5 seconds to return.
2. Press and hold the button more than 5 seconds to extended monitor;
3. Press the button once to return.
Squelch level setting
1. Press the button to set Squelch level,
2. Press the or button once to select the desired level
(Auto,1,2,3,4,5)
Press and hold the or button, the selection will move quicker.
Triple Watch setting
Press button to scanning current channel and channel 35 and 5;
2. Press button once to return.
Unless it is necessary, to avoid operation on locally used repeater input
channels (channels 31 to 38 and channels 71 to 78) or locally used repeater
receiving channels (channels 1 to 8 channels 41 to 48) is recommended.
Sending a Call Tone
With the unit in normal mode, press the button.
The microphone will be muted and the unit will transmit the current Call tone
to other users with the same channel and CTCSS code.
The TX icon will be displayed on the LCD display.
Call tone can only be transmitted once (not more than 3 sec) in any 60 sec
period.
It means that the unit will not transmit a call tone more than once no matter
how many times you press the button within a minute.
Triple Watch mode monitors channels 35 and 5 for a signal while you listen to
the currently selected channel.
1.
Repeater function
Repeater facility is a third party facility which is only available in some local
areas.
Only use this function for extending your communication range when you
know the channel of the repeater facility in your area.
Push and hold the Call key to activate the Repeater function, push and hold
the Call key again for release the Repeater function.
To Next Page
Loading...
