3
What Does This Do?
1. Mode Button - Selects the display mode (Normal or Strobe) for the
Tuning LED Array. The modes are labeled below the last two LEDs of
the Tuning LED Array.
2. Input - Connect your instrument here. This jack enables battery
power to the pedal when connected. To prolong battery life,
disconnect the cable from the Input jack when not in use. If the
optional Harman power supply is used, cables can remain connected.
3. Foot Switch Release Pins - These two pins are spring loaded
hinges that hold the Foot Switch in place. See page 14 for information
on accessing and changing the battery.
4. Foot Switch - Turns the Tuner on and off.
To Next Page
Loading...