DigiTech METAL MASTER User Manual

Connections
The Metal Master has a single input (INPUT) and a pair of outputs (AMP
and MIXER). The two outputs give you the following options: running
into a guitar amplifier, running directly to a mixing console or recording
device, or both. The MIXER output uses DigiTech’s advance CIT™
cabinet modeling technology for an authentic guitar amplifier sound
without using an amp.
Follow these setup directions before use:
1.Turn the volume down on the amplifier/mixer you are connecting to.
2. Connect the pedal output to the amplifier/mixer input.
3. Connect the guitar to the pedal input.
4. Connect the power supply to the pedal (optional).
5.Turn the level control on the pedal to the minimum position.
6.Turn up your amplifier/mixer level to the desired listening level.
7.Turn on the pedal by pressing the pedal switch and gradually turn up
the level to the desired listening level.

DigiTech METAL MASTER Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Electric Characteristics

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply voltage	100V ~ 50/60Hz, 120V ~ 60Hz, 230V ~ 50Hz, 240V ~ 50Hz

Weight and Dimensions

weight	1.38 lbs
length	4 15/16 in
width	3 1/8 in
height	2 1/8 in