DigiTech METAL MASTER User Manual

7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the chassis exposing the
battery compartment. (See battery replacement diagram.)
8. Pedal
Press the pedal to turn the effect on and off.
9. Out 1(Amp) Jack
Connect this output to your guitar amplifier.
10. Indicator LED
This LED indicates when the effect is turned on. If the LED becomes
dim or does not light when the cables are connected, the battery needs
to be replaced.
11. Out 2 (Mixer) Jack
This output features DigiTech’s CIT™ cabinet modeling technology, that
lets you run the pedal directly into a mixer or recorder input without
having to use a guitar amplifier.

DigiTech METAL MASTER Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Electric Characteristics

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply voltage	100V ~ 50/60Hz, 120V ~ 60Hz, 230V ~ 50Hz, 240V ~ 50Hz

Weight and Dimensions

weight	1.38 lbs
length	4 15/16 in
width	3 1/8 in
height	2 1/8 in