Connections
The Multi Chorus has a single input and a pair of outputs. Out 1 is
used if the Multi Chorus is being connected to only one amplifier. Out
2 is used for stereo operation. Connect Out 1 to the first amplifier
and Out 2 to the second amplifier.
The Multi Chorus also has built-in CIT™ cabinet modeling that can be
enabled. This is a useful tool when running a distortion pedal into the
Multi Chorus and then running direct into a mixer or recorder. This
creates a distortion-through-an-amplifier sound without having to use a
guitar amp.
To Enable CIT™ Cabinet Modeling:
Press the pedal down and apply power (connect a guitar cable to the
Multi Chorus input or connect the PS200R power supply to the AC
adapter jack).
CIT™ cabinet modeling has to be enabled each time you apply power to
the Multi Chorus.
To Next Page
Loading...
Need help?
General
