number, by putting the DATA SWITCH in the MIDI CHANNEL position and advancing the number
with the right foot switch. The MIDI CHANNEL numbers are shown on the LED display with two dots (.
. X X) in front of the numbers.
NOTE: The PDS-3500 operates in an "edit mode" when programming. This means that whatever values
that were previously stored in that bank and preset number are retained and displayed in the program-
ming mode. To change these values to new ones, simply advance the numbers with the foot switches.
You may have to "roll-around" to the lower number value you desire by advancing the number past the
greatest number value for that parameter back to 1. If you fail to store the newly incremented number,
the number stored in memory will remain as the active number for that preset.
To Next Page
Loading...
Need help?
General
