Stereo Operation
For stereo operation connect the guitar to the Input of the RP200.Connect a TRS stereo “Y”
cord to the RP200’s Stereo Output.Connect one end of the “Y” cord to the input of one
amplifier, channel of a mixer,or power amp.Connect the second end of the “Y” cord to a second
amplifier, second channel of a mixer,or power amp.If connecting to a mixing console, set the pan
controls of the mixer hard left and right in order to retain stereo separation and be sure to
engage the RP200’s Cabinet Emulator. See page 18 for more on selecting the Cabinet Emulator.
NOTE: When using a guitar amp, it may be best to connect the guitar to the input of the RP200
and the Output of the RP200 to the effect return of the amplifier.
7
To Next Page
Loading...
Need help?
General
