The administrator PIN is required only to initialize new Smart Cards for
the DIGITTRADE HIGH SECURITY HDD. This feature is neccessary if both
Smart Cards got lost or are defective.
If new Smart Cards are initialized, all data stored on it will be destroyed
because the hard disk needs to be formatted with process.
The preset factory PIN is “1-2-3-4-5-6-7-8”.
For security reasons it is obligatory to change this PIN to avoid data loss or
unauthorized interactions.
For further information regarding the initialization of new Smart Cards
please feel free to contact us by telephone +49 345 / 2317353 or e-mail
beratung@digittrade.de.
Changing Administrator PIN
Follow these steps to change your administrator PIN:
1) Insert Smart Card into DIGITTRADE HIGH SECURITY HDD.
2) Press the “CHANGE PIN” button and afterwards “0”.
3) Conrm your entry with “ENTER”.
4) Type in the current 8-digit administrator PIN and press “Enter” to
conrm the entry. The “STATUS” LED will ash twice.
5) Enter the new 8-digit administrator PIN and press “ENTER”.
6) For conrmation enter your new 8-digit administrator PIN again and
press “ENTER”.
7) If the change of administrator PIN was successfull the “STATUS” LED
will ash three times and you will hear two beeps.
8) The Smart Card can be removed now.
If the PIN change was not sucessful, the “ERROR” LED will ash. Press
the “ESC” button and start again with the rst step of the PIN change.
Administrator PIN
To Next Page
Loading...
Need help?
General
