of the MFP server. If it is not lit, or if it blinks, there is a
problem with the USB device or the MFP server.
USB2 Indicator is lit while a USB device connects to USB2 Port
of the MFP server. If it is not lit, or if it blinks, there is a
problem with the USB device or the MFP server.
Note : There is only one USB LED indicator for DN-13008.
⑤
. Connect Digitus MFP Server to Your Wired Network
I. Connect the MFP server to the wired network, such as a LAN switch or a
LAN hub, using a LAN cable.
II. Connect USB printers, hard drives or flash ROM disks, or all-in-one
series printers (AIO/MFP) to the MFP server using USB cables.
III. Plug in the power adaptor (included in this package) to power on the
MFP server.
⑥
. Connect Digitus DN-13018 to Your Wireless Network
Just skip this step if you are using DN-13007 or DN-13008.
I. Follow Step 5.
II. Properly set up wireless configuration as Step 8.
III. Plug-off the LAN (Ethernet) cable.
IV. Plug-off the power adapter and then plug-in the power adapter to
restart server. DN-13018 will connect to your wireless network.
⑦
. Install Utility
I. Insert the included CD-ROM into the personal computer. The
Autorun screen as Fig1 should appear.
3
To Next Page
Loading...
