Figure 1 Autorun
II. Click Install Product button.
III. Click Next, if you see any Next button in installation windows.
IV. Click Finish.
⑧
. Configure Digitus MFP Server with Utility
Using MFP Control Center Software (Fig2):
1. Open the Digitus MFP Control Center. It will automatically search the
existing servers and display their statuses.
2. Select the server that you want to configure. Double click the
selected server and enter Administrator (default: admin) and
Password (default: admin).
Figure 2 Control Center
3. Name your Digitus MFP server and select a codepage for file server
function as Fig3. Please enter the server name and the workgroup
name for Windows networking by SMB protocol. The default
server name is the model name (DN-13007 or DN-13008 or
DN-13018) and the workgroup name is “ARBEITSGRUPPE”. If you
want to use the file server function, you have to set the same
codepage as the one that your Windows PC is using.
4. Assign IP address to Digitus MFP server as Fig4. Please choose the
one method to set the IP address of the server. You can
automatically get IP by using DHCP or manually assign an IP to the
server.
4
To Next Page
Loading...
