9. Click Apply to save your settings. And the server will reboot.
10. You have now finished the procedure of setting the wireless parameters.
# In infrastructure mode, DN-13018 searches all channels to join the matched wireless
service set. In ad-hoc mode, DN-13018 searches all channels to join the matched wireless
ad-hoc service set too, however, if none are found, DN-13018 creates that service set in the
assigned channel.
# In ad-hoc mode, WPA-PSK/TKIP is not allowed.
3.2.3 Set Wireless Configuration Using Server’s Web Pages
1. You can see the IP address of MFP server in the server list. Open IE Browser and
type server’s IP address or click the Home Icon of MFP Server Control Center.
12
To Next Page
Loading...
