F. After the scanning finished, click the “Disconnect” button in the Control Center to
release the ownership of the scanner (or MFP).
The steps described above require manual “connect” and “disconnect” operations
before and after the scanning, respectively. We will introduce “auto-connect scanning”
in the following section.
7.3.4 NetUSB Scanning using Auto-Connect Scan
For NetUSB scanning, we recommend you use auto-connect scan as the following
steps.
A. In the Control Center, click the MFP server that has the desired MFP attached.
B. Click the desired MFP.
60
To Next Page
Loading...
