7
2.1 Power Connection
To power up the camera, connect the AC 24V power adaptor to the power
connector of the camera and the power outlet. Please refer to the diagram and
the pin definition table below for connection. Alternatively, users can use High
Power over Ethernet (PoE+) to power up the camera if an IEEE 802.3at 60W
PoE+ switch is available. Refer to the section below for Ethernet cable
connection.
Pin Definition
1
AC 24V 1
2
GND
3
AC 24V 2
2.2 Ethernet Cable Connection
To have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet cable to the RJ-45 connector of the camera,
and plug the other end of the cable to the network switch or PC.
NOTE: In some cases, Ethernet crossover cable might be needed when
connecting the camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs. If the LEDs are
unlit, please check the LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
To Next Page
Loading...
