5
6 Installation the Switch
This part describes how to install your Ethernet Switch and
make connections to it. Please follow the following
instructions in avoid of incorrect installation causing device
damage and security threat.
6.1 Notice the matters
• Before cleaning the switch, unplug the power plug of
the switch first. Do not clean the switch with wet cloth
or liquid.
• Do not place the switch near water or any damp area.
• Prevent water or moisture from entering the switch
chassis.
• Do not place the switch on an unstable case or desk.
The switch might be damaged severely in case of a fall.
• Ensure proper ventilation of the equipment room and
keep the ventilation vents of the switch free of
obstruction.
• Make sure that the operating voltage is the same one
labelled on the switch.
• Do not open the chassis while the switch is operating
or when electrical hazards are present to
avoid electrical shocks.
6.2 Installation environment
Before the installation, should first confirm that there is a
suitable working environment.
To Next Page
Loading...
