10
2.4 Power on the Switch
The Switches connected an external power adapter power
12V/1A supply, make sure you use the proper power supply.
AC Electrical Outlet:
It is recommended to use single-phase three-wire receptacle with
neutral outlet or multifunctional computer professional
receptacle. Please make sure to connect the metal ground
connector to the grounding source on the outlet.
DC Power Adapter Connection:
Connect the DC power connector in the back panel of the Switch
to external receptacle with the included DC Power Adapter and
check the power indicator is ON or not. When it is ON, it indicates
the power connection is OK.
2.5 Connect Computer (NIC) to the Switch
Please insert the NIC into the computer, after installing network
card driver, please connect one end of the twisted pair to RJ-45
jack of your computer, the other end will be connected to any RJ-
45 port of the Switch, the distance between Switch and computer
is around 100 meters. Once the connection is OK and the devices
are power on normally, the LINK/ACT/Speed status indicator lights
corresponding ports of the Switch.
To Next Page
Loading...
Need help?
General
