5
Installation the Switch
This part describes how to install your Ethernet Switch and make connections to it.
Please follow the following instructions in avoid of incorrect installation causing
device damage and security threat.
• Before cleaning the switch, unplug the power plug of the switch first. Do not
clean the switch with wet cloth or liquid;
• Do not place the switch near water or any damp area. Prevent water or moisture
from entering the switch chassis;
• Do not place the switch on an unstable case or desk. The switch might be
damaged severely in case of a fall;
• Ensure proper ventilation of the equipment room and keep the ventilation vents
of the switch free of obstruction;
• Make sure that the operating voltage is the same one labeled on the switch;
• Do not open the chassis while the switch is operating or when electrical hazards
are present to avoid electrical shocks.
Desktop Installation
Install the Switch on a desktop, please attach these cushioning rubber feet provided
on the bottom at each corner of the Switch in case of the external vibration. Allow
adequate space for ventilation between the device and the objects around it.
To Next Page
Loading...
Need help?
General
