8
Installation the Switch
This part describes how to install your Ethernet Switch and make
connections to it. Please follow the following instructions in avoid of
incorrect installation causing device damage and security threat.
• Before cleaning the switch, unplug the power plug first. Do not
clean the switch with wet cloth or liquid;
• Do not place the switch near water or any damp area. Prevent
water or moisture from entering the switch chassis;
• Do not place the switch on an unstable case or desk. The switch
might be damaged severely in case of a fall;
• Ensure proper ventilation of the equipment room and keep the
ventilation vents of the switch free of obstruction;
• Make sure that the operating voltage is the same one labeled on
the switch;
• Do not open the housing when the switch is in operation or when
electrical hazards are present to avoid damage.
To Next Page
Loading...
