Dimplex 314CHE - Lamp Replacement; Wall Mounting the Heater; Cleaning; Recycling

Lamp replacement
The fuel effect is secured by 2 screws, one at each end.
Slacken these screws (do not remove them fully) until the fuel
effect is released, the lift it away.
Replace the defective lamp with a 60W B22 ‘Fireglow’ lamp.
Reassemble in reverse order, ensuring that the diffuser/top
bracket arms are positioned correctly and the icker rotors
spin freely.
Each icker rotor should sit horizontally on its pin and spin
freely without fouling its mounting bracket. If necessary adjust
the bracket by bending slightly (the plastic diffuser is exable).
Wall Mounting the Heater
Three wall xing points are provided - see below.
The Positions of the xing holes are as follows.
Note the recommended maximum height above the oor is
300mm.
The heater should be mounted at sufcient height to allow easy
cleaning of the oor covering below the heater.
Mark the positions of the two xing points on the wall. Drill and
appropriately plug the xing holes. Screw in suitable round
headed screws to a depth which allows the heater to be hung
rmly in positon.
Next remove the fuel effect as described earlier to reveal
the third xing point, hang the heater on the two xings just
installed and mark the position of the third xing. Remove the
heater and plug the third hole. Ret the heater and screw x
it in postion through the third xing.
Replace the fuel effect.
Cleaning
Before cleaning the heater, disconnect it by pulling out the
plug from the wall socket. Do not use detergents, abrasive
cleaning powder or polish of any kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove
dust and a damp cloth (not wet) to clean off stains. Be careful
not to allow moisture into the heater.
To clean the reector, see ‘Maintenance’.
Recycling
For electrical products sold within the European
Community.At the end of the electrical products
useful life it should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer
for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge (subject to availability) provided it
has been installed and operated in accordance with these
instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales information or assistance
with this product, please contact 0844 879 3588 (UK) or
01 842 4833 (R.O.I.)
Please retain your receipt as proof of purchase.
Ensure icker rotors rotate freely on
pins and that lamps are in sockets
correctly