Dimplex DFB6016 - Existing Fireplace Installation

8
mayrestrictaircirculation.Ifinstallingthereplaceinacarpeted
area,placeaone-piece,solid,atsurfaceunderthereplaceinsert.
Ensurethatallfouroftheinsert’sfeetrestsecurelyonthissurface.
ExistingFireplaceInstallation
1. Sealalldraftsandventswithnon-brousinsulationmaterialsto
preventchimneydebrisfromfallingintothereplaceinsert.Donot
installintoanexistingreplacethatispronetoleaksordampness.
2. Capthetopofthechimneyuetopreventrainfromentering.
3. Planyourelectricalpowersupply(refertoNOTE1).
4. Thepowercordcanrunalongthefrontofthehearthtoanoutlet
nearthereplace.
!
NOTE 1: A15Amp,120Voltcircuitisrequired.Adedicatedcircuit
ispreferredbutnotessentialinallcases.Adedicatedcircuitwill
berequiredif,afterinstallation,thecircuitbreakertripsorfuse
blowsonaregularbasiswhentheheaterisoperating.Additional
appliances on the same circuit may exceed the current rating of the
circuitbreaker.
Figure 2
AirCirculationAreas
Rubber
Feet
25 1/2”
(64.8cm)
301/4”(76.8cm)
11 1/2”
(29.2cm)