Operation
The manual controls for the Log
Grate are located in the front right
side. (Figure 1)
A. On/Off Switch
Supplies power to the 2-Position
Switch.
B. 2-Position Switch
The 2-Position Switch toggles the
unit between Manual Operation
and Remote Operation.
Remote (Front Position): •
The unit is operated with the
remote control.
Manual (Back Position):• The
unit operates with the ames,
logs and ember bed. When
the manual control is in the
Manual position the heater
does not run.
!
NOTE: When the manual
control switch is in the Manual
position, the Log Grate unit will
not operate with the remote
control.
C. Initialization Button
Used to synchronize the supplied
remote control with the Log Grate.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cutout will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting 5
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dimplex
North America Limited at
1-800-668-6663.
Remote Control
The remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the Log Grate and can pass
through most obstacles (including
walls). It is supplied with 243
independent frequencies to
prevent interference with other
units.
Battery Installation
Depress tab on the battery 1.
cover on the back of the
remote control and remove
battery cover.
Figure 1
A
B
C
To Next Page
Loading...
Need help?
General
