Log Grate Assembly
1
CAUTION: Handle logs
carefully, they are fragile and can
easily crack or break, if dropped.
Each log is a separate component
that needs to be placed on the
grate. Position each log so that
the hook and loop dot on the
backside of the log lines up with
the corresponding hook and loop
pad on the Log Grate. These
pads assist with securing the logs
to the grate.
Each of the logs contain LED
lights to create a ickering effect.
During assembly, each log
requires the electrical connectors
on the log and grate to be
connected as they are being
placed. In some cases, these
wires will need to have tie wraps
added to prevent the wires from
being seen after nal assembly.
Hook and
Loop Pads
Wire Connectors
To Next Page
Loading...
Need help?
General
