This product is fi tted with a replaceable battery in the controls.
To replace the battery, follow the steps below, shown in Fig. 6:
1. Unhinge the heater from the wall using the clips shown in Fig. 2 and locate
the battery module.
2. Slide the catch and pull module from the controls.
3. Remove the coin cell battery and replace.
4. Slide module back in place, ensuring clip is engaged.
4
Battery positive side up
2
1
3
IMPORTANT: Before replacing the battery ensure the heater is isolated from the
electricity supply. NOTE - Battery should be disposed of in an appropriate manner
Battery Replacement
24
To Next Page
Loading...
