22
Default Boost Target Temperature
This is the default Boost Target Temperature that is used when ‘Boost Mode’ is activated.
Dened as a temperature value, this must be within the Heater’s Target Temperature Range.
If the Target Temperature Range settings are changed then the Default Boost Temperature Range will be
automatically changed to the closest valid temperature within Target Temperature Range.
Max. Boost Duration
This is the maximum length of time that the user is able to activate ‘Boost’ for.
Shown in minutes (when under an hour) or hours (if over an hour) in the following increments: 30 mins, 1
hour, 2 hours, 3 hours, 4 hours.
The value chosen will be the max allowed when boost is activated.
Boost Settings
Setback Settings
Setback is a function that only modies Timer Mode operation. When Setback is enabled it overrides any Heating
Off period to maintain a constant temperature.
This can be used to prevent the room temperature from falling below a minimum value while there is no demand
for heat (Heating Off).
The value of this temperature is restricted to a value between 7 and 18 °C. This is because Setback should not be
treated as a regular Heating On period.
Date & Time Settings
This allows the Time, Date and Daylight Savings Time settings to be modied.
Sound Settings
Audio feedback when the user presses a button can be enabled or disabled here.
‘Comms’ (Communications) Settings
This allows Wireless Connectivity features to be enabled or disabled. Entering this menu item will display a list of
available communications methods to that heater.
To Next Page
Loading...
Need help?
General
