- 5 -
Function
Compared with traditional storage heaters the amount
of energy released from the outer case of the heater
is signifi cantly reduced, resulting in lower surface
temperatures. This allows more effi cient running
because the Quantum is heating the room only when
you want it to.
The stored energy is primarily released by using a low
speed fan to ‘push’ the heat from the stored core and
into the room. Running the timed programs or adjusting
the temperature thermostat will prompt the heater to run
the fan automatically if it is required.
NOTE: THERE IS A DELAY OF UP TO TWO MINUTES
ON THE FAN OPERATION WHEN SWITCHING TO
‘Comfort On’ AND ‘Comfort Off’, THIS IS NORMAL.
Summer
When heat is not needed both wall switches may be
turned off. Turn these both back on when heat is
needed again in autumn, all of your previously
stored settings and programmes will be remembered
by the the heater.
NOTE
D
UE TO THE LOW ENERGY LOSSES FROM
THE CASING OF THE HEATER THE SURFACE
TEMPERATURE MAY APPEAR TO BE LOW, BUT
THIS IS NORMAL.
NOTE
O
CCASIONAL CLICKING SOUNDS DURING
OPERATION ARE DUE TO TEMPERATURE
CHANGES IN THE STORAGE CORE.
To Next Page
Loading...
Need help?
General
