General
This heater has been designed for tting in the space behind the plinth of oor standing
kitchen units or other tted furniture units. It is recommended that the heater is not
installed under cupboards used for storing perishable goods. It can be accommodated
in plinths with a minimum height of 120mm, and is suitable for cupboards of 500mm
width and above.
Installation
Before undertaking installation work, ensure the electricity supply is disconnected
from any relevant xed wiring.
The heater is more easily tted during the installation of new furniture units, or on
existing furniture units if they can be temporarily moved from their position against
the wall. If an existing furniture unit cannot be moved, then it may be necessary to
remove the back of the unit in order to gain access to carry out the wiring installation.
Before installing the unit consider the location with respect to the following;
• The electrical supply and cable length.
• Position heater to deliver heat eectively without causing personal discomfort
from overheating while standing at work surfaces etc.
• Minimum plinth height of 120mm and minimum furniture unit width of 500mm.
WARNING: The installation of this appliance should be carried out by a competent
electrician and be in accordance with the current IEE wiring regulations
and any local or insurance regulations.
6
To Next Page
Loading...
