11
PERFECT-TEMP STATION COMMANDER CONTROLLER –
MODEL PT-SC SERIES OPERATION INSTRUCTIONS
Introduction
The PT-SC controller (Station Commander) is configured into two independent modules, the
Operator Module and the Power Module which are linked together by an interconnecting,
low-voltage cable.
The software, or programming information, is entered and stored in the operator module
which may be wall mounted or installed in a roll-in refrigerator bezel.
The electrical connection from the building electrical supply and the output to the Perfect-
Temp cart(s) are done within the power module which is available as either a single cart
version (Single Power Module) or a eight (8) cart version (Quad Power Module).
Programming Overview
The Station Commander Operator Module is capable of being programmed to facilitate the
following:
• Program for up to eight (8) Perfect-Temp carts.
• Automatic rethermalization start for breakfast, lunch and dinner.
• Ability to accept a second start time for a second cart at breakfast, lunch and dinner.
• Independent rethermalization cycle times for each meal.
• Automatic “hold” cycle at the completion of the rethermalization cycle. “Hold” cycles
can be customized for each meal, by selecting “hold” cycle duration, heat, and no-heat
sequencing.
• Keypad entered pass codes for entry into the programming menu or for manual starting of
the rethermalization cycle.
• Programmable pass codes (2 levels).
To Next Page
Loading...
