DINGLI JCPT1412 - Operational Safety Procedures

OPERATOR’S MANUAL with Maintenance Information
Safety Rules
8
sparks.
Component Damage Hazard
Do not use any battery charger greater than
24V to charge the batteries.
Electrocution/ Burn Hazard
Connect the battery charger to
a grounded, AC 3-wire
electrical outlet only.
Inspect daily for damaged
cords, cables and wires.
Replace damaged items before operating.
Avoid electrical shock from contact with
battery terminals. Remove all rings, watches
and other jewelry.
Tip-over Hazard
Do not use batteries that weigh less than the
original equipment. Batteries are used as
counterweight and are critical to machine
stability. Each battery must weigh 28 kg. The
batteries must weigh a minimum of 112 kg.
(For JCPT0808HD/DC, JCPT1008HD/DC,
JCPT1012HD/DC); Each battery must weigh
30 kg. The batteries must weigh a minimum of
120 kg (For JCPT1212HD/DC); Each battery
must weigh 37 kg. The batteries must weigh a
minimum of 148 kg (For JCPT1412HD/DC,
JCPT1612HDB/DCB, JCPT1612HDS/DCS).
Lifting Hazard
Use the appropriate number of people and
proper lifting techniques when lifting batteries.
Lockout after Each Use
1 Select a safe parking location - firm level
surface, clear of obstruction and traffic.
2 Lower the platform.
3 Turn the key switch to the off position and
remove the key to secure from
unauthorized use.
4 Push in the red Emergency Stop buttons to
“off” position.
5 Push in the main power switch to “off”
position
6 Chock the wheels.
7 Charge the batteries.