DINGLI JCPT2212DC - Page 36

OPERATOR’S MANUAL with Maintenance Information
Operating Instructions
31
Emergency Stop
Push in the red Emergency Stop button to the
off position at the ground controls or the
platform controls to stop all machine functions.
Repair any function that operates when either
red Emergency Stop button is pushed in.
Operation from Ground
1 Turn the key switch to ground control.
2 Turn the ground red Emergency Stop
button clockwise to the on position.
3 Pull out the platform red Emergency Stop
button to the on position.
4 Be sure the battery pack is connected
before operating the machine.
To Position Platform
1 Press the lift function enable button.
2 Press the platform up/down button to
activate the up function or the down
function.
Drive and steer functions are not available
from the ground controls.
Operation from Platform
1 Turn the key switch to platform control.
2 Pull out the platform red Emergency Stop
button to the on position.
3 Turn the ground red Emergency Stop
button clockwise to the on position.
4 Be sure the battery pack is connected
before operating the machine.
To Position Platform
1 Press the lift function select button.
2 Press and hold the function enable switch
on the control handle.
3 Activate the proportional control handle in
the desired direction.
To Steer
1 Press the drive function select button.
2 Press and hold the function enable switch
on the control handle.
3 Push the steer mode select button for
steer mode (FS. bS)
4 Turn the steer wheels with the thumb
rocker switch located on the top of the
control handle.
To Drive
1 Press the drive function select button.
2 Press and hold the function enable switch
on the control handle.
3 Increase speed: Slowly move the control
handle off center.
Decrease speed: Slowly move the control
handle toward center.
Stop: Return the control handle to center or
release the function enable switch.
Use the direction arrows on the platform
controls to identify the direction the machine
will travel.
Machine travel speed is restricted when the
platform is raised.
Drive speed select
The drive controls can operate in two different
drive speed modes. When the torque speed
select button light is on, slow drive speed
mode is active. When the High speed select
button light is on, fast drive speed mode is
active.
Driving on a slope
Determine the slope and side slope ratings for
the machine and determine the slope grade.
Maximum slope rating, stowed position 25%,
Maximum side slope rating, stowed position
5°.