OPERATOR’S MANUAL with Maintenance Information
Maintenance
48
6 Use the Safety Arm. Stop the machine.
Crushing hazard. Keep
hands clear of the safety arm when lowering
the platform.
7 Inspect the center chassis area and
scissor arms for burnt, chafed and pinched
cables.
8 Inspect the following areas for burnt,
chafed, corroded, pinched and loose
wires:
· Scissor arms
· ECM to platform controls
· Power to platform wiring
9 Inspect for a liberal coating of dielectric
grease in all connections between the
ECM and the platform controls.
10 Raise the platform and return the safety
arm to the stowed position.
11 Lower the platform to the stowed position
and turn the machine off.
B-3
Inspect the Tires and Wheels
Dingli requires that this procedure be
performed every 250 hours or quarterly,
whichever comes
Maintaining the tires and wheels in good
condition is essential to safe operation and
good performance. Tire and/or wheel failure
could result in a machine tip-over. Component
damage may also result if problems are not
discovered and repaired in a timely fashion.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracks.
3 Check each lug nut for proper torque.
lug nut torque, lubricated
To Next Page
Loading...
