OPERATOR’S MANUAL with Maintenance Information
Maintenance
59
A-6
Perform 30 Day Service
The 30 day maintenance procedure is a one
time procedure to be performed after the first
30 days or 40 hours of usage. After this
interval, refer to the maintenance tables for
continued scheduled maintenance.
Perform the following maintenance
procedures:
• B-3 Inspect the Tires, Wheels and Castle
Nut Torque
• D-2 Replace the Hydraulic Tank Return
Filter Element
A-7
Grease the Steer Yokes
DINGLI requires that this procedure be
performed every 100 hours of operation.
Regular application of lubrication to the steer
yokes is essential to good machine
performance and service life. Continued use of
an insufficiently greased steer yoke will result
in component damage.
1 Open the steer yoke cover.
2 Locate the grease add hole on the top of
the steer yoke.
3 Pump multipurpose grease into the steer
yoke until the steer yoke is full and grease
is being forced past the bearings.
4 Install the cover.
5 Repeat this step for the other steer yoke.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 1 (lithium
based) or equivalent
To Next Page
Loading...
