DFW series indicators DFW_03_12.07_EN_U
56
- In weighings mode (not in SETUP environment), it is possible modify quickly the following steps, by pressing twice
consecutively the MODE key:
(!) 000.000Min.WGttot o / tot S
MAX.WGt (!) 000.000
MAX.tot
(!) 00
After having set these parameters (by pressing ENTER/PRINT into it to confirm the new value), by pressing the C key, it
returns in the weighings mode status.
The values, edited out the SETUP environment, aren’t stored permanently in the memory, so if you want to store these
values in the memory of the indicator, you have to change they in the SETUP mode.
TOTALISATION WITH PRINTING
If the presence of a printer has been configured, upon each pressing of MODE, one prints the data programmed in step
SEtuP >> SEriAL >> CoM.Prn >> Pr.ConF of the set-up environment (TECH.MAN.REF.), for example:
- Weigh number
- GROSS weight
- TARE weight
- NET weight
PRINTING AND ZEROING OF THE TOTALS
The instrument has two different total levels, a partial total and a general total, which increase upon each totalisation; these
may be printed and zeroed independently from each other.
To print and zero the PARTIAL TOTAL one should press for an instant the ENTER/PRINT key; depending on the type of
totalisation, various messages will be displayed:
- With normal totalisation the number of weighs and the accumulated total will be displayed.
- With fast or automatic totalisation the message “totAL” will be displayed.
The number of weighs made and the NET WEIGHT PARTIAL TOTAL are printed.
To print and zero the GENERAL TOTAL one should press for a few seconds the ENTER/PRINT key:
- With normal totalisation, the “G.totAL” message and then the number of weighs and the accumulated total will be
displayed.
The number of weighs made and the NET WEIGHT GENERAL TOTAL are printed.
NOTE: the data in any case may be printed until the following totalization.
In the 17-key indicator, during the weighing, it is possible to view at any time the number of weighs and the accumulated net
weight in the totals:
- By pressing in sequence the F and 7 keys, the following will be displayed in this sequence:
"n x", in which x is the number of weighs made
"totAL", followed by the accumulated PARTIAL NET TOTAL.
- By pressing in sequence the F and 6 keys, the following will be displayed in sequence:
"n x", in which x is the number of weighs made
"totAL", followed by the accumulated GENERAL NET TOTAL.
MEMORY STORAGES (only for 17-key indicator)
It is possible to memorize the weigh totalisation in one of nine memory storages (identified from 1 to 9).
- Press in sequence the F and 5 keys; the display shows " rn n ":
- Enter the desired storage number (from 1 to 9).
-
Now all the made totalisations are stored in the storage number just entered.
- To change the storage, repeat the same operations.
To recall or zero the PARTIAL TOTAL of a storage, it is necessary to recall first its identifying number, as previously
described; however the GRAND TOTAL is not available for each storage.
To Next Page
Loading...
