EasyManua.ls Logo

Dinli DL-90CC - Drive Chain and Tire Inspection

Default Icon
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Check gearbox oil level from the icon of gearbox The drive chain will wear with use and requires
cover (right side)every time before operating periodic adjustment. Remove the chain cover,
this vehicle. If oil supply to gearbox is not measure the amount of chain slack to check
enough will cause damage to the gearbox. the chain tension. The amount of slack can be
#90 gear oil (800 cc) is recommended. adjusted by lossening the lock nuts and move
the chain tensioner plate. Don’t forget to tighten
b. Engine oil back the lock nuts.
Two-stroke Engine oil must be added to the oil tank Always lubricate chain after proper adjustment.
periodically. Check oil indicator every time before Quality chain lube is recommended.
operating this vehicle.
If oil supply to engine is not enough, this engine will be
out of order. The oil tank is installed under the seat. Pull
the lamp under the seat to take off the seat. Than you
can refill the oil into the tank.
For 2-stroke engine, SAE 20 oil is recommended.
Replace with new oil per running miles 800~1000km.
33
5-E TIRES b. The tire pressure:
WARNING Check tire pressure frequently with the air gauge pressure

Related product manuals