www.dipgrinders.ro • office@dipgrinders.ro 11
7. Remove the screw in the center of the adjusting knob.
8. With the adjustment knob (item nr. 230004) on #9 (French Press), turn the
grinder on.
9. With the motor running, adjust the grind towards #1 slowly until you hear
metal scraping. (If you do not hear a metallic sound when you reach #1, pull
the knob away from the grinder and, while pulled out, set the #9 in front of the
red line and adjust the grind towards #1 as above).
10. Notice the position of the adjusting knob when you first hear metal sound.
Increase the adjustment setting counter-clockwise by one line (or half a
setting).
11. Pull the adjusting knob away from the grinder housing and, with it pulled,
position the #1 to be in front of the red arrow.
12. Grind a handful of beans on #1, and the output should be a powder. After
completion, on any setting, YOU SHOULD NEVER HEAR METAL SOUND.
13. Tighten the screw in the center of the adjusting knob.
14. IF YOUR GRIND IS NOT POWER, REPEAT THE INSTALLATION SECTION.
6. SHUT-DOWN AND DISMANTLING
Whenever it is decided that an appliance of this type will no longer be used, it is
recommended to make it inoperable by cutting the power cord after having disconnected
the plug from the power socket. It is also recommended to make those parts of the
appliance liable to create hazard danger-proof.
Store the machine in a suitable place, out of reach of children or unsuitable people. For
dismantling as refuse, deliver the appliance to an authorized refuse collection center.
Do not dispose of it in the environment.
To Next Page
Loading...