12
© 2003 directed electronics, inc.
H1/3 WHITE/BLUE -) 200 mA channel 3 output: This wire supplies a (-) 200 mA out-
put whenever the button on transmitter programmed for channel 3 is pressed. This out-
put is used to control optional accessories. This channel can be programmed to pro-
vide the following types of output (see feature programming section of this guide).
1. A validity output will send a signal as the transmission is received.
2. Second unlock output when the unlock button is pressed a second time after
disarming the system. This can be used to unlock the passenger doors when
installing progressive door locks.
IIMMPPOORRTTAANNTT!!
Zones 2 and 4 are shunted when this channel becomes active. Zones
2 and 4 reactivate 5-seconds after this output ceases.
NNOOTTEE::
Other features can be programmed to channel 3 using the Bitwriter
®
.
H1/4 BLACK/WHITE (-) 200 mA domelight-supervision output: Connect this wire to
the optional domelight supervision relay.
IIMMPPOORRTTAANNTT!!
This output is only intended to drive a relay. It cannot be connected
directly to the domelight circuit, as the output cannot support the current draw of one
or more bulbs.
To Next Page
Loading...
