© 2003 directed electronics, inc.
23
to enter feature programming routine
1. Open a door.
2. Turn the ignition on and then off.
3. Within 5-seconds, press and hold the integrated LED/Valet
®
switch. After 3-sec-
onds the horn will sound once to indicate entry into the first features menu. To select
the second features menu, continue to hold the integrated LED/Valet
®
switch until the
horn sounds twice. Once the desired menu is selected, release the integrated
LED/Valet
®
switch.
4. Within 5-seconds, press and release the integrated LED/Valet
®
switch the number
of times corresponding to the desired feature listed below. Then press the integrated
LED/Valet
®
switch one more time and hold. The horn will sound the number of times
equal to the feature number selected.
5. While holding the integrated LED/Valet
®
switch, selecte the feature by either press-
ing for 1 short horn honk setting or pressing for 2 short horn honk setting.
once a feature is programmed
z
Another feature(s) can be programmed.
z
The other feature menu can be selected.
z
The Learn Routine can be exited.
accessing another feature
z
Release, then press and release the integrated LED/Valet
®
switch the number of
times to advance from the feature just programmed to the next feature desired.
z
Press and hold the integrated LED/Valet
®
switch once more.
To Next Page
Loading...
