© 2005 Directed Electronics—all rights reserved
19
d
Connect & Disconnect from PC
CONNECT PMP3520 TO COMPUTER
1. Press the button to power on the PMP3520.
2. Plug the mini-end of the supplied USB cable to the PMP3520, and the other
end to your computer’s USB port.
3. Once the PMP3520 is connected to your computer, it should be detected by
your computer operating system automatically. You will see the following
two messages on the PMP3520.
NOTE: While the first message temporarily displays below and the com-
puter is connected to the PMP3520, DO NOT press the REC but-
ton! This activates the automatic download function (the entire-
ty of the PC hard drive will start to download to the PMP3520!
To Next Page
Loading...
Need help?
General