26
© 2008 Directed Electronics. All rights reserved.
To activate Smart Start mode:
Press the • button on the remote 3 times and then press the
button.
The parking lights flash 5 times fast to confirm the remote is in Smart Start
mode.
To activate Smart Start mode with a manual transmission:
Enter the MTS procedure.1.
Exit the vehicle and press the 2. button on the remote (the vehicle shuts
down when locking).
Press the 3. button on the remote 3 times and then press the
button.
The parking lights flash 5 times fast to confirm the remote is in Smart Start
mode.
When Smart Start is activated the system checks the vehicles voltage or
internal temperature, based on the programmed timer mode settings. ( every
3 hours for a total of 6 remote start cycles) If there are any changes to timer
mode, the Smart Start monitoring is also affected.
For example:
When Smart Start is activated, the system checks the vehicle's voltage and
internal temperature every 3 hours. If thresholds have been met or exceeded,
the remote start activates and runs for the programmed duration. This is count-
ed as one remote start activation, with five remote start activations remaining.
Voltage and temperature thresholds are checked again in 3 hours, and if
thresholds have NOT been met remote start does not activate, and there are
five remote starts remaining.
Use one of the below methods to exit Smart Start mode:
Perform the same steps you followed to activate Smart Start mode•
Turn the ignition On•
Press the brake pedal•
The parking lights flash 5 times slowly to confirm the remote has exited Smart
Start mode.
To Next Page
Loading...
Need help?
General
