Directed Electronics Smart start - Aux 2; OEM-Style Alarm; Intrusion Codes Via Horn

User guide P.13
Press AUX 2X QUICK ¾ AUX ¾ START/STOP: ................. STOP
Press AUX 2X QUICK ¾ AUX ¾ TRUNK: ........................... TRUNK
Note: Pressing the AUX button 2x quickly causes the LED to flash slowly and to shift to level 1
(AUX 2, configurable by your installer). Pressing the AUX button 3x quickly causes the LED to
flash fast and to shift to level 2 (second car operation).
AUX2
If configured at installation, this feature can be activated by pressing the 2x on the AUX button (or
“Shift level 1”), followed by pressing the button while the LED is slowly flashing.
OEMStyleAlarm
The OEM-style alarm (if configured by your installer) monitors the doors, hood and ignition switch
of your vehicle. It will sound the horn if a door or the hood is opened, or if the key is turned in the
ignition.
• To arm the OEM-style alarm, press the button on the transmitter.
- The OEM-style alarm will ONLY arm if the button on the transmitter is pressed.
- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now
armed.
• To disarm the OEM-style alarm, press the
button on the transmitter.
- To stop the horn from sounding if the OEM-style alarm is triggered, press the or
button, or put the system in and out of Valet Mode (page-8)
IntrusionCodesviahorn
The system monitors the following:
• Doors
• Hood
• Ignition
Note: If an intrusion has occurred the HORN will sound for a maximum of 1 minute.
If an intrusion has occurred and pressed, the horn provides an intrusion code corresponding to
the type of intrusion that occurred.
Diagnostic table:
1x = power interruption 4x = Doors intrusion
3x = Hood 6x = Ignition
