18
A. Locate the coaxial cable connected on the “Towards LNB” end of the
Connected Home Adapter (see image below). Disconnect the coaxial cable
from the Connected Home Adapter and reconnect it to the coaxial connector
on your DCCK device labeled “Towards LNB”.
This section describes how to connect your DCCK device if your installation uses one or more Connected Home Adapter units.
In this installation, you will use the enclosed coaxial cable. The Ethernet cable included with your DCCK will not be used,
but the existing Ethernet cable between your DIRECTV
®
Receiver and the Connected Home Adapter must remain connected.
directv
®
whole-home dvr service
comPatible with connected home adaPter connection
B. Unscrew the cap from the coaxial connector
labeled “SAT Rcvr” on your DCCK.
Remove Cap from “SAT Rcvr” on DCCK Device
Disconnect Coaxial Cable from
Connected Home Adapter
Connect Coaxial to “Towards
LNB” on DCCK Device
To Next Page
Loading...