1-Lead equipment power cable up to the vehicle´s battery, gluing plastic supports on rear cabin side and faste-
ning it with anges. Once cabin has been folded, lead cable along lower cabin side, fastening it with clamps
and M4 screws and up to battery with anges. It must follow the same passage as original cable (thoroughly
clean the area before gluing plastic supports). When connecting equipment to battery, it will carry out a test
of all its leds, CP will show on the display and it will then be turned off.
IMPORTANT: Due to the complex electronic control system of the unit, the current supply
connection must be made directly to the battery, not to any other existing point available to feed
other vehicle accessory or appliance, taking care of not changing polarity (2). Should polarity
be inverted, electronic system of the unit could irreversebly be damaged.
IMPORTANT: Please consult User’s Guide before starting.
1
Wiring
supply
Detailed instructions
on power wiring assembly
2
2
+
-
dirna, s.a.
EN
To Next Page
Loading...
