3
Cleaning and user maintenance must not be made
by children without supervision.
Keep ngers, hair and loose clothing away
from moving parts and openings whilst using the
stick vac.
Don’t use the stick vac if it has been dropped,
damaged, immersed in water or left outdoors.
Don’t handle the charger plug or use the stick
vac with wet hands.
Don’t use the stick vac charger if the charger
cord or plug is damaged.
Don’t unplug the charger by pulling on the
charger cord.
Power supply
Don’t charge the stick vac outdoors, or leave
the charger connected to the mains when not in
use.
Don’t use the stick vac with the incorrect
charger as this may result in damage or injury to
the user. The correct charger information is listed
on the ratings label.
Always use the charger supplied with the
stick vac. If charging the stick vac through an
extension cord, use only CE approved 13amp
extension cords, non-approved extension cords
may overheat. Care should be taken to arrange
the extension cord as it can be a trip hazard.
Brushbar
Storage
Store your stick vac in a cool, dry area. If lters
have been cleaned as per user guide instructions
ensure they are thoroughly dry before storing
away. This stick vac does not stay upright without
constant support. Between uses, lie at on the
oor in a suitable location so that it does not
become a trip hazard or can be stepped on.
EN
CAUTION: If the brushbar in the
powered head has been obstructed,
the brushbar motor protection sensor may
have been activated. The brushbar will stop
and the light on the powered head will
illuminate red. To reset switch the brushbar
and stick vac o, remove the powered head
from the reach wand/handheld and clear any
obstruction. Wait 1 minute before retting
the powered head tool, switch the stick vac on
and press the brushbar ON/OFF button.
WARNING: The brushbar in the
powered head constantly rotates
when switched on. Never use the powered
head on one spot for an extended period
of time as the brushbar may damage the
oor surface. Always turn the powered head
brushbar o when cleaning hard oors. To
prevent any damage being sustained, test on
an inconspicuous area of the ooring rst.
!
To Next Page
Loading...
