Dirt Devil EV3320 - Operating Steps; Power and Cleaning Modes; Pausing and Charging

10
NOTE:
• If the battery level is too low to start sweep,
please charge it rst.
• Before sweep, all wires on the ground
should be well organized for fear of power
interruption or damage to articles caused
by pulling the power cord during sweep.
• In the auto sweep mode, by default the
robot vacuum will do sweeping twice if the
sweep duration is shorter than 10 minutes.
• Do not move the charging dock during
cleaning, and make sure that the charging
dock is powered on, otherwise the robotic
vacuum cleaner may not be able to return
for charging.
OPERATING STEPS
• Press and hold “ ” for 3 seconds to start it up.
• Press and hold “ ” for 3 seconds to shut it down.
Press “ ” to start the AUTO SWEEP mode. Once it
is started, the robot vacuum will leave the charging
dock, and begin cleaning in a “Z” pattern, and then
clean areas along the wall. It repeats the above
process continuously until cleaning of the whole
room is completed.
During the operation of the machine,
pressing any key will stop the operation.
POWER BUTTON
CLEANING
SPOT CLEANING
Move the sweeping robot to the area to be cleaned,
press “ ” button twice to start the cleaning mode.
The robotic vacuum cleaner will sweep a rectangular
area of 1.5m X 1.5m centered on itself. After such
specic area has been swept, the robot vacuum will
automatically return to the charging dock.
AUTO/MANUAL CHARGING
• AUTO RECHARGE: After sweep, the robot vacuum
will automatically return to the charging dock
for charging.
•MANUAL RECHARGE:
a. If it is paused, press “ ” to recharge the
robot vacuum automatically
b. When the robot vacuum is stuck or cannot nd
the charging dock, manually return it to the
charging dock for charging.
PAUSING ROBOT
NOTE: The spot cleaning mode can not be started
when the robotic vacuum cleaner is on the
charging dock.