EasyManua.ls Logo

Dirt Devil Quick Clean EV0201BU - Cleaning and Maintenance; Emptying Dust bin

Dirt Devil Quick Clean EV0201BU
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
EMPTYING DUST BIN
To achieve the best performance, empty the dust bin and clean the dust bin lter after every use.
Always switch off and unplug the appliance from the ac power outlet before any maintenance or cleaning.
• Clean the outside of the appliance and inside the dust bin with a damp cloth. Dry thoroughly before use.
• Never immerse the appliance in the water.
TO REMOVE THE DUST BIN, press down on the dust bin assembly
release button and remove dust bin from the main body of unit.
Remove any clogs that might be located in the suction port or lter port area.
Position dust bin area of vacuum over a waste receptacle.
Press down on the dust bin release button to open dust lid
and allow contents to drop into waste receptacle.
Reinstall and insert the dust bin into the slots
on the bottom of the main body. Then, press
the dust bin into locked slot and click into place.
CLEANING DUAL LAYER PERFORMANCE FILTER
The felt lter and primary lter are xed together and located inside the dust bin lid. It is recommended to clean the felt
lter and primary lter with cold water at least once a month. Check the felt lter and primary lter frequently and clean
when dirty.
Remove the dust bin as outlined in the Emptying Dust Bin section above.
Hold the dust bin, pull the dust bin lid latch and open the lid.
Remove the felt lter and primary lter from the dust bin using the small plastic
tab attached on the lter.
Use a soft brush to remove loose debris from the felt lter and primary lter.
Then rinse with cold water. DO NOT USE DETERGENT OR SOAP. Rinse and
gently squeeze dry the lters. Set lters aside and allow to air dry for 24 hours.
Place the primary lter and felt lter back into the dust bin lid and close the dust
bin lid until you hear a click.
Reinstall the dust bin into the main body.
u
v
w
x
y
U
u
v
w
x
CLEANING AND MAINTENANCE
A
C
B
A
B
C
C
ATTENTION:
NEVER OPERATE THE APPLIANCE
WITHOUT DUST BIN FILTER IN PLACE.
If suction power seems to diminish, it may be time to empty the dust bin or clean or replace the lter.

Related product manuals