Place vacuum cleaner in the upright locked position.
Press the hose release latch button and release the
lower hose end from the lower hose connection.
Insert the hose end into the upper hose connection
as shown until you hear a “Click”.
Press the wand release button and lift up the wand.
Choose the desired accessory and insert into the wand .
Plug the power cord into a wall outlet. Press the POWER
button to turn the vacuum cleaner on.
Once you have completed vacuuming, press the power
button again. Remove the accessory and unplug the power
cord plug from the outlet.
IMPORTANT:
The brush roller in oor head continues to rotate
when using the vacuum with accessories. DO NOT place vacuum
on the deep pile carpet to avoid damage to carpet.
ATTENTION:
Make sure to re-insert the hose end into the lower hose connection before using the vacuum in upright mode.
7
w
x
y
U
V
ACCESSORY ATTACHMENT
OPERATING INSTRUCTIONS
u
v
2-in-1 CREVICE/BRUSH COMBINATION TOOL:
• Use CREVICE position for narrow suction dirt and debris between cushions, in
corners, and along wall and counter-top edges. Can be used on blinds, lamp
shades, vents and other narrow areas.
• Rotate accessory tip counter-clockwise to use the BRUSH position on fabrics,
curtains, and cushions. Avoid adding pressure to allow the brush to help with
the suction on textiles. Always clean accessory before using on fabrics
CAUTION:
DO NOT pull the vacuum cleaner around the room by the hose. Property damage
or personal injury could result.
CAUTION:
Before assembling or disassembling unit and accessories, always ensure that the
appliance has been unplugged from the wall outlet! Make sure that the appliance is switched off
and unplugged.
ATTENTION:
When using accessories, be careful not to overextend the hose when reaching
to avoid tipping the vacuum over.
TIP: You can also choose to use your vacuum
cleaner by inserting the 2-in-1 Crevice/Brush
tool directly into the hose.
C
B
A
C
D
B
“Click”
A
D
To Next Page
Loading...
