CAUTION: Wrapping the cord too tightly with excessive stress on the cord may cause cord
damage. A damaged cord is an electrical shock hazard and could cause personal injury or damage.
5
NOTE:
To remove the handle from the main body, press the WAND
RELEASE BUTTON and pull the handle upward away from the main body.
NOTE:
Make sure the upper cord hook is in the upright position as shown. Wrap the power
cord loosely around the upper and lower cord hooks.
ALWAYS DISCONNECT THE APPLIANCE FROM THE ELECTRIC OUTLET
BEFORE ASSEMBLING OR DISASSEMBLING UNIT OR ACCESSORIES.
GENERAL ASSEMBLY
Insert the wand handle into the main body until you hear a “click”.
u
Install the hose onto the main body. Align the
locking tab of the hose with the main body.
Insert hose and lock the end of the hose by
rotating to the left.
Drape the hose over the storage holder .
Insert the other end of the hose into the
lower hose connection until you hear a "CLICK."
Insert the 2-in-1 Crevice/Brush tool onto the
accessory storage .
v
w
x
y
A
C
D
B
E
E
D
E
F
C
D
A
B
“Click”
Align
F
To Next Page
Loading...
