Operation Overview - 26 FM13V/FM13X Operator’s Manual
Planning
Planning
1. Gather information about jobsite (page 30).
2. Inspect jobsite (page 30).
3. Check supplies and prepare equipment (page 32).
Setting Up at Jobsite
1. Prepare jobsite (page 31).
2. Position fluid unit and connect to drilling unit. See drilling unit operator’s manual.
3. Block trailer wheels.
Mixing Fluid
1. Ensure valve in suction line and at least one valve on the pressure side of the pump is open.
2. If necessary, choke cold engine.
3. Move throttle to half open.
IMPORTANT: Leave unit hitched to towing vehicle or properly stabilized.
Jobsite hazards could cause death or serious injury. Use
correct equipment and work methods. Use and maintain proper safety
equipment.
NOTICE:
• Wear personal protective equipment including hard hat, safety eye wear, and hearing protection.
• Do not wear jewelry or loose clothing.
Improper handling or use of chemicals may result in illness, injury, or
equipment damage. Follow instructions on labels and in material safety data sheets
(MSDS).
To Next Page
Loading...
