Maintenance - 66 SK800 Operator’s Manual
Procedures
Check
1. Disconnect battery at battery disconnect
switch, if equipped.
2. Ensure no ignition sources are near battery.
3. Loosen and remove battery cable clamps
carefully, negative (-) cable first.
4. Clean cable clamps and terminals to remove
dull glaze.
5. Check for signs of internal corrosion in cables.
6. Connect battery cable clamps, positive (+)
cable first.
7. Tighten any loose connections.
8. Ensure that battery tiedowns are secure.
9. Turn battery disconnect, if equipped, on.
To Next Page
