DITEC ENTREMATIC SMART RESET - Page 37

- 37 -
0DT833 12/03/2012
47E
FUSES
ID Value Dimension Circuit
F1 - F2 12A - 500V 10.3 x 38 monoSKaVe Oine
ADJUSTMENT LIMIT SWITCH
1. Set tKe deceOeration ramSV to zero. (T5 - T6)
2. CaOiErate tKe Oimit VwitcK (C) on tKe Jearmotor Vo tKe door VtoSV a SSroximateO\
200-300mm Irom tKe cOoVXre Soint.
3. CaOiErate tKe oSeninJ Oimit VwitcK (A) at tKe oSeninJ Soint.
4. CaOiErate VOowdown Oimit VwitcK (B) in VXcK a wa\ tKat it enJaJeV at
a
SSroximateO\ ô oI tKe oSeninJ VtroNe.
5. CaOiErate tKe oSeninJ VSeedV XVinJ trimmer (T3) and cOoVXre (T4).
6. CaOiErate tKe oSeninJ (T5) and cOoVXre (T6) trimmerV oI tKe deceOeration
ramSV in VXcK a wa\ aV to caXVe VtoSSinJ in tKe actXaO door oSen and door
cOoVed SoVitionV
.
C
B
A
B
C
300
A
¾
J1
1
230 V 50/60 Hz
LN
GND
CNT
T2
T4
T6
T1
T3
T5
DL1011 9 8 7 6 5 4 3 2 1
12
15
1617
13
14
41402098432110LAMP1111213
+F -F U V W
ON
OFF
1 2 3 4
U24
J2
ON
F2F1
$OZD\VFXWWKHMXPSHU-RQGRRU60$575(6(7
COMMAND TROUBLE VERIFY
Every command, in every
curtain position
The curtain and the motors
don’t move
 ControO Xnit teVt waV IaiOed
(Oed 13 Jreen OFF, Oed 14 red ON)
Opening Command The motor run with slog or
it doesn’t reach to the right
speed (the brake wasn’t
activated)
 See tKe EridJe J2 it mXVt Ee cXt
'XULQJWKHFORVLQJ
movement
The motors doesn’t made
deceleration ramp
 AdMXVtment oI tKe cOoVinJ Oimit VwitcK (C) at 300 mm Irom
tKe Àoor
 AdMXVtment oI tKe deceOeration ramS E\ meanV tKe trimmer T6
NB for general diagnostics see also at page. 39
TROUBLESHOOTING
EN