DiversiTech International Ltd.
Glaisdale Drive East, NG8 4LY
Nottingham United Kingdom
Email sales@pumph.co.uk
Phone +44(0)115 900 5858
22
FOR FURTHER INSTALLATION ADVICE PLEASE CALL THE TECHNICAL SUPPORT HELPLINE ON 0115 900 5858.
• When you set the air conditioner in
AUTO mode, it will automatically select
cooling, heating(cooling only models
without), or fan only operation depending
on what temperature you have selected
and the room temperature.
• The air conditioner will control room
temperature automatically round the
temperature point set by you.
• Under AUTO mode, you can not select
the fan speed.
NOTE: Under AUTO mode, both the
AUTO mode and the actual operation mode
indicator lights illuminate for some models.
• Press the “MODE” button until the”FAN
“ indicator light comes on.
• Press the “FAN SPEED” button to choose
the fan speed. The temperature can not
be adjusted.
• Do not put the duct to window.
• When the unit is on, press the Timer
button will initiate the Auto-off stop
program, the TIMER OFF indicator
light illuminates. Press the UP or down
button to select the desired time. Press
the TIMER button again within 5
seconds, the Auto-on start program is
initiated. And the TIMER ON indicator
light illuminates. Press the up or down
button to select the desired Auto-on
start time.
• When the unit is off, press the Timer
button to initiate the Auto-on start
program, press it again within 5 seconds
will initiate the Auto-off stop program.
• Press or hold the UP or DOWN button
to change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control
will count down the time remaining until
start.
• The system will automatically revert back
to display the previous temperature
setting if there is no operation in a 5
seconds period.
• Turning the unit ON or OFF at any time
or adjusting the timer setting to 0.0 will
cancel the Auto Start/Stop timer program.
• Press this button, the selected
temperature will increase(cooling) or
decrease(heating) by 1°C/2°F(or 1°F)
30 minutes. The temperature will then
increase (cooling) or decrease (heating) by
another 1°C/2°F(or 1°F) after an additional
30 minutes. This new temperature will be
maintained for 7 hours before it returns
to the originally selected temperature.
This ends the Sleep/Eco mode and the
unit will continue to operate as originally
programmed.
NOTE: This feature is unavailabe under FAN
or DRY mode.
OPERATING INSTRUCTIONS
AUTO OPERATION
FAN OPERATION
TIMER OPERATION
SLEEP(ECO) OPERATION
NOTE: The following control panels are for explanation purpose only. The control panel of
the unit you purchased may be slightly different according to the models. Your machine may
not contain some indicators or buttons. The actual shape shall prevail.
NOTE: The following control panels are for explanation purpose only. The control panel of
the unit you purchased may be slightly different according to the models. Your machine may
not contain some indicators or buttons. The actual shape shall prevail.
CONTROL PANEL FEATURES
OTHER FEATURES
PAC-H-12
To Next Page
Loading...