DIVERSITECH PAC-H-12 - Page 23

DiversiTech International Ltd.
Glaisdale Drive East, NG8 4LY
Nottingham United Kingdom
Email sales@pumph.co.uk
Phone +44(0)115 900 5858
23
FOR FURTHER INSTALLATION ADVICE PLEASE CALL THE TECHNICAL SUPPORT HELPLINE ON 0115 900 5858.
NOTE:This feature can be activated from the
remote control ONLY. The remote control
serves as a remote thermostat allowing
for the precise temperature control at its
location.
• To activate the Follow Me/Temp Sensing
feature, point the remote control towards
the unit and press the Follow Me/Temp
Sensing button. The remote control will
send this signal to the air conditioner
until press the Follow Me/Temp Sensing
button again. If the unit does not receive
the Follow Me/Temp Sensing signal during
any 7 minutes interval, the unit will exit the
Follow Me/Temp Sensing mode.
NOTE: This feature is unavailabe under FAN
or DRY mode.
If the unit breaks off unexpectedly due to the
power cut, it will restart with the previous
function setting automatically when the
power resumes.
• When the Power is ON, the louver opens
fully.
• Press the SWING button on the panel
or remote controller to initiate the Auto
swing feature. The louver willl swing up
and down automatically.
• Please do not adjust the louver manually.
After the unit has stopped, it can not be
restarted operation in the rst 3 minutes.
This is to protect the unit. Operation will
automatically start after 3 minutes.
Under cooling operation, when the ambient
temperature is lower than the setting
temperature for a period of time, the unit will
be automatically operate power management
feature. The compressor and fan motor stop.
When the ambient temperature is higher
than the setting temperature, the unit will be
automatically quit the power management
feature. The compressor and (or) fan motor
run.
• During dehumidifying modes, remove
the upper drain plug from the back of
the unit, install the drain connector(5/8”
universal female mender) with 3/4”
hose(locally purchased). For the models
without drain connector, just attach the
drain hose to the hole. Place the open
end of the hose directly over the drain
area in your basement oor.
• During heating pump mode, remove the
lower drain plug from the back of the unit,
install the drain connector (5/8” universal
female mender) with 3/4” hose(locally
purchased). For the models without drain
connector, just attach the drain hose to
the hole. Place the open end of the Hose
adaptor directly over the drain area in
your basement oor.
OPERATING INSTRUCTIONS
FOLLOW ME/TEMP SENSING
FEATURE (ON SOME MODELS)
AUTO-RESTART
AIR FLOW DIRECTION
ADJUSTMENT
WAIT 3 MINUTES BEFORE
RESUMING OPERATION
POWER MANAGEMENT
FEATURE (ON SOME MODELS)
WATER DRAINAGE
NOTE: The following control panels are for explanation purpose only. The control panel of
the unit you purchased may be slightly different according to the models. Your machine may
not contain some indicators or buttons. The actual shape shall prevail.
OTHER FEATURES
PORTABLE AIR CONDITIONER
PAC-H-12